⅝" threaded to ¾" slip adapter.stl

I made a 5/8" threaded to a 3/4" slip adapter that I use to go from my pump to a 3/4 inch PVC pipe. The pump has a non-standard 5/8 inch threaded connection that is hard to find parts for.

Threaded ⅝ inch to ¾ inch pipe adapter.stl

I found the last one was a bit too tight when screwed into a 3/4" adapter. I made a slight adjustment to that. I changed the tightening hexagon to an octagon and increased the thickness by 1mm to a total of 4mm. I had one break when I was tightening it all down into the pump and so I am trying again with 0.15mm layer height and another layer on the wall. Hoping this will pan out. If it still breaks then I will try some other filaments.

5-8 inch to 3-4 inch pipe adapter.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

dalaketh

Achievements

Seedling

Trailblazer

⅝" threaded to ¾" slip adapter.stl

Threaded ⅝ inch to ¾ inch pipe adapter.stl