Jack Skellington Band Poster

A quirky little Halloween print of Jack Skellington as if he's in a pop-punk band. You can replace the green with any colour you think fits, and the Teal with any light colour (grey, beige etc). Have fun!

As with other Hueforge models, an AMS or an MMU is not necessary. All you have to do is set pauses where the filament swaps are being done, and then load the new filament in before resuming the print.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4

• PLA BambuLab Basic BambuLab Green Transmission Distance: 8

• PLA META Sunlu Teal Transmission Distance: 5.4

• PLA Kingroon White Transmission Distance: 8

Swap Instructions:

• Start with Black
• At layer #10 (0.96mm) swap to BambuLab Green
• At layer #17 (1.52mm) swap to Teal
• At layer #23 (2mm) swap to White for the rest.