Photo-Threaded Pad Mount

A pretty dead-simple way to stick a 1/4"-20 threaded photographic mount on something. Use double-sided anchoring tape or glue. Print in flexible TPU for a pad that will conform to a curved surface.

Threads are printed in, so don't expect it to hold tons and tons - they'll strip easily, but it's enough to hold onto lightweight stuff like a phone or small light.

MagSafe Phone Mount

A MagSafe-compatible mount (non-charging, just a holder) for iPhone 12 and later, with a 1/4"-20 thread on one side for a photographic tripod or similar. Requires 19 6x3 mm disc magnets - [I used these.](https://www.amazon.com/gp/product/B00HA2LM30/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1) Make sure you get the orientation correct as you put them in - similar poles should face the center.

Print in flexible TPU for a non-marring mount, but PETG or PLA work fine too. Use a tool or hex key to push the magnets in. Works through cases that support MagSafe charging. Modeled in OpenSCAD; you could probably subtract a volume out of the middle on the phone side to accept the guts of a Qi charger and have a mount that charges, too.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

crashfrog

Achievements

Seedling

Trailblazer

Photo-Threaded Pad Mount

MagSafe Phone Mount