A pretty dead-simple way to stick a 1/4"-20 threaded photographic mount on something. Use double-sided anchoring tape or glue. Print in flexible TPU for a pad that will conform to a curved surface.

Threads are printed in, so don't expect it to hold tons and tons - they'll strip easily, but it's enough to hold onto lightweight stuff like a phone or small light.

Photo-Threaded Pad Mount

A MagSafe-compatible mount (non-charging, just a holder) for iPhone 12 and later, with a 1/4"-20 thread on one side for a photographic tripod or similar. Requires 19 6x3 mm disc magnets - [I used these.](https://www.amazon.com/gp/product/B00HA2LM30/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1) Make sure you get the orientation correct as you put them in - similar poles should face the center.

Print in flexible TPU for a non-marring mount, but PETG or PLA work fine too. Use a tool or hex key to push the magnets in. Works through cases that support MagSafe charging. Modeled in OpenSCAD; you could probably subtract a volume out of the middle on the phone side to accept the guts of a Qi charger and have a mount that charges, too.

MagSafe Phone Mount

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

crashfrog

Photo-Threaded Pad Mount

MagSafe Phone Mount