43 Likes158 DownloadsFebruary 15, 2024
For holding screwdrivers. Prints "flat" like most of the Multiboard stuff. Should be wide enough to fit most screwdrivers, but is thin enough to fit them in adjacent peg holes.
I probably rounded the rods a little too much, so you may run into issues with the print not sticking if you don't like using skirts/ your bed adhesion isn't super good, but I was able to print it with no issues.
Feedback welcome.
Category:
43 Likes158 DownloadsFebruary 15, 2024
143 Likes158 DownloadsFebruary 15, 2024