Nimble V1 and V6 mount for Creality CR-10

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2554334.

This is an older solution. Check out this thing for a better, more complete kit: Nimble V1 print head for Creality type.

For the print head kit for the Nimble Version 2 family, have a look at Nimble and Sidewinder V2 mounts for the Creality type print heads

Complex mount to mount the Nimble extruder and a E3D V6 hot end on the Creality CR-10. This is based on the work done by Chito on this thing: https://www.thingiverse.com/thing:2494642

There are various fan mounts, including a mount to use the Berd-Air system. There are two sensor options, a BL Touch and a Ezable. If you need more sensors, drop me a line.

The mount is attached to the carriage plate using the 2 mount points and a screw that slides into the threaded hole in the plate. The screw needed is an M3x6 and can be tightened through the mount body. If you have any issues or comments on this thing, feel free to contact me.

There is also a Nimble Sidewinder version available: https://www.thingiverse.com/thing:2663204

Edit 3: Added a BL Touch mount for use on the Volcano hot end, as it is 8 mm taller.

Edit2: Careful, the Fang style cooler probably will not fit. It will hit the cross bar at the top.

Edit: What is this fascination with fang style coolers in the CR-10 community? Anyway, you asked, we promised and as promised, delivered. Only caveat here, I have not printed this thing out, so test at your own "risk" I have added a fang style cooler and a special V6 clamp and it now also holds the 40x40 fan for the V6 and the ducting to guide it to the heat-sink. I thought it would be better to split the forces between the fang and the clamp.
To mount, install the Mount, Slide the Fang down into the grooves on the side and tighten the bolts through the Fang lightly. Then mount the V6, Clamp and the Nimble. Adjust the height of the Fang and tighten the 2 bolts. Mount the fan on top and mount the Hot end fan last. There is a little loop to tie-wrap the fan cable to the Clamp. Check the Fang height again and you are done.

The STL models are checked and optimised. The parts that need a different orientation to print properly are rotated to the preferred printing position.

With an installed weight of less than 27 grams on your carriage/effector the Zesty Nimble is smallest and lightest extruder you can buy, it has ample torque and can be mounted in multiple orientations.

The Nimble is available from Zesty Technology.