CNC collet storage blocks for the Gridfinity modular workshop storage system - they're both ER11 for now. Gridfinity is the ultimate organizer for your whole workshop! Learn more at Find more Gridfinity accessories at https://bit.ly/3E2NxnZ Parametric source files: - Stupid Version: https://a360.co/3JznS7x - Non-Stupid Version: https://a360.co/3M0PDar These bad boys hold CNC collets - I only have an ER11 Snapmaker, so that's what ya get. **The stupid version** holds collets in their little yellow boxes. **The non-stupid version** holds the collets without the boxes. There's no reason to use the stupid version. Just remember to keep the collets nice and oiled to prevent rust. **Gridfinity Tips!** - No brims or support required! - Use any filament with an 0.6mm or smaller nozzle. - Wider bins can curl, so maximize your bed adhesion if you're going big! - All storage blocks are compatible with all baseplates! - Most storage blocks are stackable! - You can add 6x2mm magnets to the corners! They won't magnetize the contents. - You can also use M3 screws in the corners.