This is a small ashtray that fits in any pocket. With its screwable lid it seals the smell and waste safe in your pocket until you empty it. Keep your environment clean!

Print instructions: This is tested with PLA: At 0.2mm layer hight you should allow five top and bottom layers and 3 perimeters. The bottom is designed to be 3mm thick, so with a layer hight of 0.2mm there should be 1mm of infill. The infill is meant to act as a barrier for the heat when you put out your cigarette.

Don't leave your cigarette to rest in this ashtray, It is only meant for putting it out.

Thanks for keeping our environment clean! :-)