The Mini Swag Lamp can be printed and used with the hanging votive LED candle swag setup or without as a table top tealight holder.
The lamp is to be used with a small tealight/votive LED candle only! do not expose model to heat or fire.
Files contained: Frame - Print with 8mm brims and 20% infill
Gem (Print Quantity 18) - Print with resin for best results.
Skinny Gem (Print Quantity 9) - Print with resin for best results. This is for the center ring of gems.
Votive Hangers (Print Quantity 3) - Print in place flat.
Votive Holder - Print with minimal supports.
Chain 2 Lengths - print at 45 degree angle to the plate and use 6mm brims. No supports.
Chaintop - print flat and use 4mm brims to prevent warping.
Wallhook - Print flat. Print 2 additional gems for this.