New version of the RetroMaker 1967 TV https://than.gs/m/639400, prints flat and has holes to insert 6mm diameter by 2mm thick rare earth magnets. https://www.amazon.com/dp/B096LYVGPS This is meant to be a refrigerator magnet or attach to any flat metal surface. The center screen area is an empty area for HueForge prints that are 89.7mm x 68.6mm (Dr. Who insert shown in picture).
Prints flat with supports in the screen area only - 3MF File has included supports. Pause at layer 12 (0.2mm layer height) to insert the magnets, be VERY CAREFUL pushing them in, support the buildplate underneath if possible to not deflect the surface of the plate. Make sure they are flush with the paused surface as to not impede the nozzle movements.
Use the .3MF for full 4-color painted print.
Creative Commons Licenses 4.0 BY-NC-ND - Attribution, Non-Commercial, No Derivitives. A commercial license to sell these prints any many others is available by subscribing to my Thangs Commercial Partner membership plan.