I'm still prepping for my booth coming up in November and wanted to have a way to elevate my prints. I found some 6"x24" tiles at the hardware store and got to it, this is the final version. Each side has two pieces that slide together at the middle tile point. There are three total plates to print on the bambu printer. One plate will have both top sections, make sure to have the indented part up so you wont need supports. The other two plates are one of the bottoms for each print.
Recommended Printing settings - 0.4mm Nozzle Printing at 0.20mm Standard settings in bambu Studio Filament type: PLA/PETG (bambu matte blue in photo) Infill % : 15% Infill Pattern: Gyroid Supports: NO Brim: yes if not enclosed printer Raft: N0 Skirt: No
COMMERCIAL LICENSE - With your active support to Rytek through this Thangs membership you have a commercial license to legally sell 3D prints of my designs on any online platform or physical store or booth of your choice. You must be the one printing the files as the file is not to be shared. All digital files are NOT to be resold or redistributed by any means. - This commercial license is only valid during your active Thangs Membership support. If you decide to no longer support my Thangs account the commercial license will end at the time your paid access expires.