Welcome to pegboard madness!! These plastic pegboards are available at the dollar tree for $1.25 per panel (or for a two pack of the small boards) and an awesome way to display your jewelry, keychains and other products. Up until now, as far as I know there hasn't been an easy solution to use them as a good looking display. One of my Thangs members asked me if I could design a few display mounts and hangers for these and this is where we are so far! All of the pieces are easy to slide in and take apart, making for easy transport and storage between craft shows. I look forward to your comments and suggestions to make them better and to add on more hangers you my need. when using two panels, it fits perfectly on the top tile of my tile riser stand, however you could go as far as having 3 or more next to each other using multiple middle base pieces on a table.
The long hanger has grooves so you can hook earrings in them, let me know if you like the grooves or if you would prefer it flat.
COMMERCIAL LICENSE - With your active support to Rytek through this Thangs membership you have a commercial license to legally sell 3D prints of my designs on any online platform or physical store or booth of your choice. You must be the one printing the files as the file is not to be shared. All digital files are NOT to be resold or redistributed by any means. - This commercial license is only valid during your active Thangs Membership support. If you decide to no longer support my Thangs account the commercial license will end at the time your paid access expires.
Recommended Printing settings - 0.4mm Nozzle Printing at 0.20mm Standard settings in bambu Studio Filament type: PLA Infill % : 15% Infill Pattern: Gyroid Supports: Only for the top side mounts, I had the best success using standard supports for these. The other pieces do not require supports. Brim: No Raft: N0 Skirt: No