Description Introducing the Rose Pen, a model that combines the elegance of a rose with the practicality of a pen.
This model includes two holders for the pen as shown in green and red in the above pictures: one that holds the pen at a slight angle and another that holds the pen upright. Additionally, the model includes two distinct flower designs for the rose, allowing for customization to suit individual preferences.
Pen Insert: 🔗 Link to purchase pen inserts
Assembly: The pen refill should be inserted into the rose stem and slid smoothly up to a certain point. After that, press the pen against the table with a little force to pop the refill into the stem permanently. The plastic on the pen refill should sit flush with the end of the stem.
🚨🚨🚨🚨🚨🚨
This model is for personal use only. If you want to sell physical prints of our designs, or you want to support us, please SUBSCRIBE TO OUR THANGS MEMBERSHIP PLAN : https://than.gs/u/161490?plans=true
🚨🚨🚨🚨🚨🚨
Print Settings:
Stem:
Orientation: Oriented the stem at a 30-degree angle, with the leaves close to the bed and the hole on the stem raised up. Infill: 100% Supports: Enabled and set to tree supports; build plate only Layerheight: 0.1mm
Rose Head:
Orientation: place the flat side on the print bed with the flower upright Infill: 25% Supports: no supports Layerheight: 0.1mm
Pen Holders:
Orientation: place the flat side on the print bed with the hole facing upward Infill: 60-100% Supports: no supports Layerheight: 0.1mm