Description Introducing the Rose Pen, a model that combines the elegance of a rose with the practicality of a pen.

This model includes two holders for the pen as shown in green and red in the above pictures: one that holds the pen at a slight angle and another that holds the pen upright. Additionally, the model includes two distinct flower designs for the rose, allowing for customization to suit individual preferences.

Pen Insert: 🔗 Link to purchase pen inserts

Assembly: The pen refill should be inserted into the rose stem and slid smoothly up to a certain point. After that, press the pen against the table with a little force to pop the refill into the stem permanently. The plastic on the pen refill should sit flush with the end of the stem.

🚨🚨🚨🚨🚨🚨

This model is for personal use only. If you want to sell physical prints of our designs, or you want to support us, please SUBSCRIBE TO OUR THANGS MEMBERSHIP PLAN : https://than.gs/u/161490?plans=true

🚨🚨🚨🚨🚨🚨

Print Settings:

Stem:

Orientation: Oriented the stem at a 30-degree angle, with the leaves close to the bed and the hole on the stem raised up. Infill: 100% Supports: Enabled and set to tree supports; build plate only Layerheight: 0.1mm

Rose Head:

Orientation: place the flat side on the print bed with the flower upright Infill: 25% Supports: no supports Layerheight: 0.1mm

Pen Holders:

Orientation: place the flat side on the print bed with the hole facing upward Infill: 60-100% Supports: no supports Layerheight: 0.1mm