Poodlecorn

Badge pin cap for needles

by
Poodlecorn
Follow
Follow
Remix Model
Poodlecorn
Poodlecorn
|
Image 2 of 4
Badge pin cap for needles 3d model
Poodlecorn
Poodlecorn
|
Image 2 of 4
Badge pin cap for needles 3d model
2D
3D
Makes
Badge pin cap for needles 3d model
Badge pin cap for needles 3d model
Badge pin cap for needles 3d model
Badge pin cap for needles 3d model

This is a cap for DIY badge pins using regular needles and pins. I made this because I did not have any of the thicker pins made for this project, so I instead cut up regular pins and glued them on the backs of my badges.

Again is 0.9 mm and again but bigger is 1 mm, so hopefully one of those work. I made the badges/pins by laminating paper in hot glue, and I glued the pins on with epoxy.


3 Likes0 DownloadsMay 21, 2024


3 Likes0 DownloadsMay 21, 2024