Liberty Charger Magnet

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used: PLA Polyterra Black PLA Esun Pine Green PLA Bambu Blue Gray PLA Bambu Jade White

Swap Instructions: Start with Charcoal Black At layer #10 (0.88mm) swap to Pine Green At layer #12 (1.04mm) swap to Jade White At layer #14 (1.2mm) swap to Charcoal Black At layer #16 (1.36mm) swap to Blue Gray At layer #19 (1.6mm) swap to Jade White for the rest.

Hueforge Affiliate: https://shop.thehueforge.com/?aff=6

Patreon: https://www.patreon.com/NeoKoiPrints

Youtube: https://www.youtube.com/@NeoKoiPrints

Tiktok: https://www.tiktok.com/@neokoiprints

Instagram: https://www.instagram.com/neokoiprints