Slider Maze Level 2

If you have enjoyed the sliding number puzzle or sliding block pictures then the Slider Maze will be the perfect next thing for you! Can you complete the challenge? All the paths have to be connected - not a single path is useless as you must connect them all without a path leading into the wall. The only exception is the one tile that has a path that ends in the middle of the tile!

The maze consists of 24 times and 1 empty space so that you could move the tiles around. This is a print in place design that requires no supports, however, It might require a little wiggle for the tiles to come separate after the print (based on the print settings).

Can you solve it? It’s not as simple as you would think! But if you are up for a challenge then print this rather quick print in place slider maze and enjoy!

Don't forget to like the design page if you like the model

Printing specifications:

Print Dimensions: base of the Slider maze is 14.2 cm ( 5.6 inches) by 14.2 cm (5.6 inches), height of this part is 0.7 cm (0.28 inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 2 hours and 53 minutes Amount of material required: ~ 28 m (83 grams)