Ender 3 cable management overhaul

HotendCableMount.3mf

Ender 3 dual extrusion purge bucket

This is the culmination of months of rigours testing.

This part mounts to the front of the bed on and Ender 3 3D Printer (tested on an Ender 3 Pro) via the bed screw mounts.

**Components needed**

Silicon pastry brush (I sourced mine from [Woolworths Australia](https://www.woolworths.com.au/shop/productdetails/521878/essentials-pastry-brush-assorted))
M4 nuts * 4
3D printed Ender 3(pro/v2) tool tray
Part

**Installation instructions**

1. Install the tool tray according to its instructions
2. Remove the heated bed, being careful to stow all the screws
3. Remove glass from the top of the bed
4. Attach nuts to the bolts protruding from the bed on the front left, and both back bolts. Tighten them.
5. Place the part on the final, exposed screw with the nut trapped inside
6. Tighten
7. Cut the brush part off the pastry brush
8. Gently push in the pastry brush bristles into the holder, being careful not to snap it
9. Reassemble the 3D printer
10. 

**Gcode tuning**

Attached below is a link to my tool change script compatible with PrusaSlicer, and SuperSlicer. You will need to tune all of the values to suit your specific machine.

[Toolchange script](https://zerobin.net/?b67b5e871c96693f#Co+3Q53HR/0whN7umENIKP67g/YYYV9+xa4jYO+4aE0=)
[Start script](https://zerobin.net/?9c26320f6c840eec#2arvBmFHdkqWLWRghAzNGejNCC/5MooYnEQVIerUNDo=)

**Hardware tuning**
You will have to move your endatops slightly, in my case just a bolt used for sensorless homing.

**DISCLAIMER**
I AM NOT RESPONSIBLE FOR ANY DAMAGE THIS MAY CAUSE. THIS MODEL IS SUPPLIED 'AS IS' AND WITH NO WARRANTY WHATSOEVER. USE AT YOUR OWN RISC!!!

Vertical Lifter Limit switch

switchMount.3mf

Limelight 2(+) Pan Tilt mount

panbase.3mf

HDD Dock for SATA drives

side.3mf

Ender 3 bed level test (dual extrusion) / offset calibration

MKS TFT32 Display adaptor Ender3, 5, clones, ect.)

2020 Extrusion Support

Ford Focus ST Badge (+ Stand)

STLogoKeyring006.stl

Limelight Tilt mount

Apple Watch Magnetic Charging Stand

Stand.stl

Extruder mount for Creality Machines (improved filament path, supports dual extrusion)

2020 Extruder motor bracket

Activity related to collaborating with others on models

Likes, comments, and activity from your community

New content from your premium memberships

Emails and messages from designers you follow

Get notified when someone purchases your models or memberships

LordBBQ

Achievements

Seedling

Debutant