This is for the Brillar series of LED strips commonly sold in Australian retailers. I have found that the remotes that came for these never had a wall mount or any way to mount them very effectively. A few iterations and a little design time later and I have this design that works well. Printing wise: I used a brim on my older printer but on my new direct drives found that I didn't need one. No infill is needed and I personally printed the final versions at 0.2 as they were getting puttied and sprayed.
*** Revisions V1.0 – Original concept design, no real success in this other than establishing absolute failure. V1.1 – Increased opening distance and added some branding. No easy way to attach to wall other than double sided tape. Didn’t print well 40% of the time in testing. V1.2 – Useable results achieved after adding a backing, changing from sketch extrude to a extrude shell idea. This worked for the project and the images are based on this. Some failures and minor print issues. V1.3 – Updated Clearances and added mouse ears to make easier to print well at high speed. Increased the opening width slightly to allow for minor over extrusion.