Is it a chicken or an egg? I guess it's both 😅. This was a fun design for me. After many test prints, it finally came together nicely. It prints in two pieces that are hollowed out, so you can store stuff inside. Both pieces screw together perfectly, so your chicken egg won't fall apart.
PRINT SETTINGS:
Supports: Yes, use one tree support for the underside of the chicken top piece.
Seam Position: Back (So it's not going through the face)
.2mm layer height
*Variable layer height makes smoother curved prints, but it is not necessary for this print.
Tested with PLA only.
PRINT DIMENSIONS:
The chicken egg container is 67mm x 67mm x 82mm
WATCH THE VIDEO & FOLLOW ME AT:
Category:
2 Likes0 DownloadsJune 24, 2024