It consists of two pieces. The dock and the lid.

Your original Nintendo switch and dock drop perfectly into a slot at the back of the new upgraded dock. (Only tested with OLED version, but it should work with the original as well; it just might not be a perfect fit.)

Then there is a compartment at the front of the new upgraded dock that holds two extra joycons, four joycon straps, and up to six game cartridges.

All the accessories have perfect cutouts, so everything slides right into place and doesn't move.

The lid is also magnetic, so it stays in place as well.

Their are three versions (As seem in my YouTube video), cut panels, full panels and wide panels. The cut panels version.

PRINT SETTINGS:

These are very straightforward prints.

The dock and the lid have spots to embed magnets. I HIGHLY RECOMMEND USING A DROP OF SUPER GLUE WHEN INSTALLING THE MAGNETS, SO THEY DON'T POP OUT WHEN THE PRINT HEAD GOES OVER THEM.

You will need 4, 6 by 3mm Neodymium Magnets. These are the magnets I use if you are interested:

60 Pack on Amazon: https://amzn.to/47pQFaj

100 Pack on Amazon: https://amzn.to/3Sa8beg

Also, if you would like to see how I designed these docks, you can find them on my YouTube channel. Just hit the join button.

Cheers,

Kevin

Disclaimer: Some links in this description may be affiliate links. This means I may earn a small commission if you click them and make a purchase. It's no extra cost to you, but it truly helps me to keep producing free designs. Thank you!