A playful controller stand designed to keep your setup clean and your controller always ready to charge.

The Cactus Controller Stand is a support-free, beginner-friendly model made for official-size controllers (PlayStation, Xbox, Switch). It’s an easy two-color print, with a removable flower cable clip that routes your USB cable cleanly through the stand.

Print it. Snap it. Plug in. Done.

🤯 Smart USB cable pass-through The flower on top isn’t just decoration. It’s a snap-on cable clip:

• Feed the cable through the clip
• Snap the flower onto the cactus top
• Remove it anytime by pinching , then clip it back in seconds

The cable route is designed with an entry at the back / bottom and an exit on the top, right where your controller sits

✅ Easy two-color printing (or AMS)

• No AMS required
• No dual nozzle required
• Print it in two colors with a simple pause & swap
• Or print it multi-color with AMS

The included 3MF is already set up for the color change

💡 Support-free, stress-free This model is 100% support-free, made to print cleanly and reliably.

Simple assembly (press-fit) Two parts only:

• Base + cactus body
• Flower cable clip

No glue. Just press-fit.

🎨 Printing Details: Nozzle: 0.4 mm Layer Height: 0.2 mm Infill: Hatch (8%) Supports: OFF (not needed!) Walls: 2 Minimum Build Volume: Fits on A1 bed

Join the conversation We’d love to see your prints! Share them on our Holoprops Discord and connect with the community: 👉 https://discord.gg/HT47N9r7Y6

Licensing All Holoprops models are 100% original creations, hand-sculpted with care and creativity. These models are our own intellectual property and are protected accordingly. Personal use only. For commercial rights, join our Merchant Tier:

👉 https://thangs.com/designer/Holoprops/memberships

Filaments used Polymaker PLA.