Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4616921.
10/8/2020: I have updated this and changed the design (v2) where the mount does NOT touch the carbon fiber. This design has better RSSI. It is a tight fit, so it won't come out during flight. I may design a cover for it, but it should stay in no problem.
10/6/2020: Use at your own risk! I plan on making some more modifications soon, because this seems to be a little too close to the frame. Stay tuned, but feel free to try this if you would like!
This is a mount for the Immersion RC Ghost antenna that fits on the Flywoo LR Explorer. It is mounted very similar to Crossfire, under or above the camera.
Print this in PLA, PETG, or TPU. I have not tested TPU yet but it should work as long as your bridging (cooling fan) is good. This should be a simple/quick print, no supports are required.
I will try to post pictures eventually, but Thingiverse is not allowing me to upload because it wants them smaller than 500K.
I recommend watching Josh Bardwell's video on installing Ghost. The manual from Immersion RC is also very helpful. The hardest part of doing the upgrade on the Flywoo is getting access to the pin because the wires are pretty tight.
To mount, run the antenna through the bottom plate, if mounting on the bottom. Make sure it is tucked in well. Remove the screws, put the mount in, and tighten up. It should be a nice and tight fit. After that, connect the antenna. Put the heat shrink on it, then solder the 3 wires (GND, 5V and solder to the TX connection). See the manual for more detail.. It covers it really well.
Best of luck and I hope you find this useful!