Foldable Jack o'Lantern - Trans face V 2.0
Foldable jack o lanterns have been a huge hit. I am deeply grateful to our customers. However, the surface was too smooth and could not express the texture of an actual pumpkin. So this time, I designed version 2.0 by expressing the surface texture of the pumpkin and making it more realistic.
This jack o' lantern is very simply made up of two parts: a body and a stem. This design focuses on lighting effects, so the eyes, nose, and mouth are made very thin. So, we designed it so that the light spreads out softly.
The assembly method is very simple, just insert the ends of the body pieces into the stem one by one.
One thing to be careful about when printing is that there is a risk that the outer parts may fall off during printing. Therefore, please pay attention to bed/plate adhesion. If bed/plate adhesion is poor, we recommend using Raft.
To put an LED tea candle inside, pull out about three strands of the body, insert the LED tea candle, and then insert the remaining body pieces.
Happy Halloween!
Total Build Time : 19h / Plastic Weight : 75.5g
Largest part in printing, size = X 162mm, Y 162mm, Z 29mm, After full assembly size= X 87mm, Y 87mm, Z 89mm Design by GOODesign