This gear is a replacement for the gear in the Dremel Model 220 workstation. To mount it to the original shaft simply hammer it in and it will hold well. I recommend printing it with 100% concentric infill or with infinite perimeters. Print it on the flat side. Requires no supports. Remember to pre-tension the spring and set the set screws tight so there is no play and also lube with a plastic safe grease like Super Lube. If there are any questions leave a comment. Enjoy!

Dremel model 220 workstation replacement gear

dremel replacement gear.stl

This is a torch base for the dremel or lexivon standing torches that acts as a regular base but with the added feature of allowing you to use it with the gridfinity system. For most printers the 0.15mm or 0.1mm tolerance version should be a tight fit and a permanent base. the 0.25mm and 0.2mm tolerance versions should be looser more like a holder that stays on the gridfinity baseplate.
 The tolerances are in regards to the radius.
Magnets are recommended for extra stability.

Gridfinity Dremel\Lexivon Torch Base

0.15mm tolerance.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

DondeEstaLaBiblioteca

Achievements

Seedling

Voyager

Dremel model 220 workstation replacement gear

Gridfinity Dremel\Lexivon Torch Base