tracking pixel
DaveMakesStuff

Nose Box

by
DaveMakesStuff
Follow
Follow
Remix Model
DaveMakesStuff
DaveMakesStuff
Image 1 of 6
Nose Box 3d model
2D
3D
Makes
Nose Box 3d model
Nose Box 3d model
Nose Box 3d model
Nose Box 3d model
Nose Box 3d model
Nose Box - Loving Your Work - 3d model
This model is restricted by licensing terms. 
105 Likes265 DownloadsOctober 29, 2022
This model is restricted by licensing terms. 


Make Flu Season more festive this year with this offbeat Nose Box tissue dispenser! Give it to a friend? Bring it to the office? Who nose, it just might catch on!

See here for video: https://youtu.be/7JLSfzse0xQ

This nose box is sized to fit an 11x11x13cm tissue box such as the one pictured.

The box prints upside-down to eliminate the need to build supports for the noses. You’ll need to put in a small amount of support under the open edge where the lid inserts. Given the relatively small footprint on the first layer, brim is recommended.

The lid should be snug to slide in at first. Slide it back and forth a few times to smooth out contact surfaces. If it is still too tight, file a very small amount off the slide surfaces of the lid, retesting the fit as you go. Don’t take too much off or the lid will be loose!

If noses on boxes aren’t your thing and you’re just looking for a plain tissue box, try this one: https://social.thangs.com/m/451804 . See here for video: https://youtu.be/isOyi836-U0


105 Likes265 DownloadsOctober 29, 2022





This model is restricted by licensing terms. 
105 Likes265 DownloadsOctober 29, 2022
This model is restricted by licensing terms.