Updates: added 2 new ring sizes that are thinner and bend easier for more of a "one size fits all" in 14mm and 18mm. Also changed the legs on the small and medium size spiders to be better optimized for printing at .4 line width.

A large, medium, and small spider that snaps onto a ring for you to wear on Halloween. Included are 7 different size rings ranging from 13mm to 23mm for the right fit.

I would recommend to make sure the ring fits your finger before joining the spider because it is pretty much permanently attached at that point.

The jaws need some tiny supports, but everything else printed fine without supports.

This was a fun little project for me so I hope you enjoy it too. I will be handing these out with candy on Halloween to spread some 3d printing joy.

Since this spider has a snap fit design, I may add more accessories if there is demand for it. Let me know in the comments if there's something you want to snap this spider onto and I'll try to make it happen.