DRAPED ELEGANCE | Table Lamp
Want to buy a physical 3D print of this product? Head to Trajann online store.
Enhance your space with our captivating table lamp shade that mirrors the natural charm of a draped fabric. This shade bathes your surroundings in gentle, warm light, creating an inviting atmosphere that effortlessly combines elegance with an organic touch.
It rests on a sleek tripod, designed for either E14 or E26 & E27 bulb sockets.
This lamp shade was designed to be printed fast, in a couple of hours in vase mode.
You can get the power cords from Amazon here: For Europe: E27 cord: https://amzn.to/3OVrZjK E14 cord: https://amzn.to/3TchBqs
For the US: E26/E27 cord: https://amzn.to/3U0Xyvy
There are 2 versions of the lamp:
- the original one
- and a smaller version that can fit on PRUSA printers with 210 x 120 x 220mm printing volume.
Also, each shade comes in 2 versions:
- a smooth surface version (the original)
- and a textured version with little bumps all over to make it look more like paper/fabric, which helps hiding little printing defects.
SHADE (Large) | Ø 230 x H 225 mm | Printing: 2h ~ 3h (vase mode) SHADE (For Prusa) | Ø 208 x H 218 mm | Printing: 2h ~ 3h (vase mode)
E14 BASE (Large) | W 200mm x L 175mm x H 107 mm | Printing: 2h ~ 3h E14 BASE (for Prusa) | W 180mm x L 157mm x H 107 mm | Printing: 2h ~ 3h
E26/E27 BASE (Large) | W 200mm x L 175mm x H 107 mm | Printing: 2h ~ 3h E26/E27 BASE (for Prusa) | W 180mm x L 157mm x H 107 mm | Printing: 2h ~ 3h
3D PRINT SETTINGS
SHADE: The shade must be printed with bottom and top faces "open". You can either use the "spiralize" function to print in "vase mode" with 1 wall perimeter only (fine for the smooth shade version). If you want 2 lines in your walls (recommended for the textured shade), do not activate "spiralize", but instead use the following settings: Resolution: 0.2 to 0.3mm / layer or less Wall Line Count: 2 Infill: None Top layers: 0 (to get rid of the top face) Bottom layers: 0 (to get rid of the bottom face) Build adhesion type: 6 to 8mm brim Supports: None
BASE: The base must be printed upside-down, so with the feet pointing up, and the round opening for the E14 socket on the printing bed. Resolution: 0.2 to 0.3mm / layer or less Wall Line Count: 2 Infill: 15 to 20% gyroid Build adhesion type: 6 to 8mm brim Supports: None