DnD mini holder

Important Note make sure to print the clips with the clip part on the build plate, and the square part sticking up, and print the end stops on their side (so it looks like an L from the top down) this orientation makes the parts stronger, and more accurate.

This mini holder allows you to safely organize, store, and transport your miniatures, without damaging them in any way.

Assembly:

• Print out your desired length of holder.
• Cut a rubber band, and thread it through the holes on one side of the holder.
• Tie knots on both ends to secure, and repeat for the other side.
• Glue clips and end stops to container of choice, or print storage box and slide in. (the holder should clip in and out fairly easily)
• Enjoy, knowing your minis are safe.