bathroom towel bar adapter

a simple piece to connect a bar that was from a closet, just pop one of this, in each side of the bar. i used strong double sided tape to attach the adapters to the wall. super clean, there is no need for supports just print the piece on the orientation of the 3d photo (flat side down).

*side note: this piece has a 1mm socket for double side tape, if your double side tape is thinner, just cut a 1mm piece in the slicer (its easy nowdays) and it becomes flat, or cut the right height for the tape. It was just a way to hide the tape joint to the wall, more clean look.

i recommend print in PETG but for indoors, PLA is just fine. regular print, .2 layer, regular infill.