!!UPDATED VERSION!! I have made a simple but important update to the Multiboard Bolt Driver: The depth of the socket has doubled so there is less slipping when driving bolts. note: Ignore V2 as that was an error in uploading the model with my 4D brand. V3 is the updated, brandless version.
Updated slicer settings I confirmed that although printing this horizontally is the correct orientation for toughness, it requires a substantial support which ruins the texture of one side of the driver and results in a rough edge. Additionally, if you do not add supports to the socket, it will sag and will therefore be unusable - ask me how I know.
Standard 0.2mm except: 4 Wall Line Count - Increases sturdiness 10% Infill - results in a lighter weight driver 10mm Brim - Not required but I was more comfortable printing vertically with a brim
This is a remix of "Screw Driver" by megatron321
( https://www.thingiverse.com/thing:709811 )
This screw driver has been adapted to drive MULTIBOARD bolts and T-Bolts. After installing and removing so many multiboard bolts, my fingers hurt terribly so I created a tool to easily install and remove the bolts. It is designed to fit both plain and flat bolts as well as plain and flat t-bolts.
I added grooves along the head to indicate the sides of the bolts to assist with lining them up with the multiboard tiles. There are two smaller grooves that indicate the top/bottom points of the t-bolts.
I added a custom brand to the handle base. The file does not have the brand.
It fits perfectly in a Multiboard Horizontal Pole Mount when attached to my Multiboard Multitool Holder.