Boiling Cauldron Fidget

This Boiling Cauldron Fidget is sure to brew up a lot of fun this Halloween season 👻 Print in place magnets cause the brew to boil when rotated. You can also stir it with the stick for the same effect.

Please note: You will need (10) 6mm x 3mm neodymium magnets for each fidget

Here is an Amazon link to the magnets and filament I used: https://amzn.to/3ZkJ7Fy

**3D Print Settings: ** PLA works great 0.2mm Layer Height 15% Infill (except for ‘Stirring Stick’ which is 75% infill) Outer Wall Speed 100mm/s (this is to help blend the layer lines) No supports needed Outer brim on ‘peg’ piece (Glow-in-the-dark PLA makes them extra fun:)

I have also included a 3MF file with the following print profiles: Print plate #1: one color; pause added at layer 27 (layer height 4.20mm) to insert magnets (make sure to orientate the magnets correctly - see photo/video), outer brim on peg piece

Print plate #2: one color; pause added at layer 27 (layer height 4.20mm) to insert magnets (make sure to orientate the magnets correctly - see photo/video)

Print Plate #3: one color, outer brim, 75% infill

To assemble: insert the boiling brew piece into the cauldron body, insert peg into cauldron bottom, then slide those two parts together. Add a drop of super glue onto the end of the ‘stirring stick’ and insert it into the small hole in ‘boiling brew’ (let dry before stirring:)

Have fun printing!