Twisty2 Egg Container

TwistyEgg2.stl

Twisty Egg Container

TwistyEgg1.stl

Geometric Egg Container

GeoEgg1.stl

Voronoi Egg Containers

VorEgg2.stl

Tennis Ball Doggy Bag Holder

Tennis Ball Doggy Bag Holder Top.3mf

3030 Extrusion Mount For 3 Wago 222-413 Blocks

I designed this for mains wiring up a 3D printer under the hood. The Voron SW uses 2 power supplys, and needs some wiring to be done. I could have used blades, and made a wire harness, but I wanted something I could easily take apart to service. I could have used wire nuts, but they sort of suck. I settles on Wago 222-413 connector blocks. This part is designed to hold 3 of them for the ground, common, and neutral wires from mains wiring.

It is designed with the Voron Swithwire in mind, but it should work on any frame with enough clearance for the Wago connectors and the wires.

Wago connectors snap into place, and are held quite firmly. You can remove them, but it take a bit of force.

Print in ABS or PETG at 40% infill; PLA will work too, but this is most likely going to be under your heated bed with your electronics, making ABS the correct choice.

Snorlax Pokemon Egg Container-Bank

Snorlax_EggContainer.stl

Carrot Shaped Doggy Bag Holder

Carrot Doggy Bag Holder.STEP

Crokinole Disk Rack

This rack holds 12 Traditional (1 1/8" Diameter or Tournament (1 1/4" diameter) Crokinole disks 

Scalloped Candle Holder Pair

Scalloped Taper Candle Holder.STL

crab pen holder

Cute crab pen holder, modelled after the Ahnitol Crab

crab.stl

90's Inspired Desk Organizer

90s Desk Organizer.STEP

Simple Caliper Desk Mount

Just a very simple desk holder for a typical vernier caliper.

USB SD MicroSD holder

Basket Weave Egg Container

WovenEgg.stl

teethBrushed - toothBrush holder

**teethBrushed**


The clean, edged curves give your bathroom a new and fresh expression. Perfect for the entire family. Daily teeth cleaning can be complete with our integrated floss stick section. Sometimes the smallest changes can make a big difference.


teethBrushed holds; 4 toothbrushes comfortably, toothpaste tube, dental floss stick.

(remote holder) LED lights

Dont know if this will help anyone else but this holds a remote for my LED light 

Microscope Slide Holder

A microscope slide holder for 26 x 76 x 1mm (1" x 3" x 3/64") microscope slides. It can hold up to 3 slides, makes comparing slides easier. Sometimes I have to check 20+ samples and also compare them at times. This helps me do it without swapping slides each and every time.

The microscope slide holder dimensions are:

86 x 128 x 3 mm

The slide holder fits on our Olympus inverted microscope with linear rail holders.

Infill percentage doesn't really matter, 100% will increase print time slightly compared to lower percentages. I did mine 100%.

cogex remote holder.stl

wall mount holder for cogex light remote

0.2mm layers
20% infill
2 perimeters/walls
no support
no brim/raft
can fit 39.6x17mm remotes

Wire Staple Holder

This is something I made for my work, to help hold staples with magnets while you hammer them in. Sometimes it's really a pain in the rear to hold the staple and wire and hammer it into the wall all at the same time. A normal 12/2 or 14/2 staple should fit in the grooves just right so you can hit it with your hammer and not worry about smacking your hand or the staple falling.

These are the magnets I used for this device (you can also find them on banggood.com, 2x10x20mm magnets):

https://amzn.to/3dFwZnV

Holder

Newest

Categories

New Uploads

Trending

Popular

Paid

Videos

New Uploads

Downloads

Trending

Popular

Paid

Videos

New Uploads

Downloads

Twisty2 Egg Container

Twisty Egg Container

Geometric Egg Container

Voronoi Egg Containers

Tennis Ball Doggy Bag Holder

3030 Extrusion Mount For 3 Wago 222-413 Blocks

Snorlax Pokemon Egg Container-Bank

Carrot Shaped Doggy Bag Holder

Crokinole Disk Rack

Scalloped Candle Holder Pair

crab pen holder

90's Inspired Desk Organizer

Simple Caliper Desk Mount

USB SD MicroSD holder

View 14 new models

teethBrushed - toothBrush holder

(remote holder) LED lights

Microscope Slide Holder

cogex remote holder.stl

Wire Staple Holder