Artillery Sidewinder X1 and X2 5015 part cooling fan duct.

822 downloads · 4 years ago · A remix of my preferred fan duct to fit a 5015 fan. This will clear the leveling probe on the Sidewi

Description

A remix of my preferred fan duct to fit a 5015 fan. This will clear the leveling probe on the Sidewinder X2.

Community Makes (1)

Community Makes (1)

Discussions

sebsafari3 years ago

Note for anyone printing at home: You'll need some hardware:

2 M3x8mm
2 M3x25mm
2 M3 nuts for the 25mm

eazrael3 years ago

Exactly. 20mm screws as stated on the ethereal page are just to short.

carlhowells882 years ago

Wendi2 years ago

I have tried it on a genius pro and it does not fit well, the angle where it curves under the sheet metal where it is screwed in stumbles and you have to force it, not sticking well, so that it separates and does not touch the bed before the nozzle, this means that in addition to being unsightly, it does not give the air where it should although it works

ovar04092 years ago

How did you print this? I tried the Cold Side without support below the "triangle" arms (where the fan is attached) but it fails ... Should I also add support there?