Covers for the floor rails to prevent crumbs and dirt from falling in.

"Front" pieces feature a cutout for the front metal pin. "Base" pieces do not have an extra cutout.

Fits the T7 Tour (and likely other 3-seat models), allowing all seats to be positioned as far back as possible while keeping the area clean. This ensures the floor rails are adequately covered from the seats forward. (As shown in the photo)

I designed several covers - but after testing - these performed the best. Especially if frequently installed and removed, as we do for camping trips.

On the sides there are small "dots" to increase the friction a little. So that they don't move around if not pressed against a seat.

Always make sure that the seats "click in place" properly after installing the covers!

Also I added a shortening aid. But you need at least 2 tools on your 3D printer to print that part properly. (PLA + PETG supports for example)

Recommended material: **PETG **- Or other more heat resistant & tough materials.

Recommended Nozzle size: 0,6 mm