This morning someone asked for a raven skull drawer pull as I sat down to work, not knowing what to make. So in an opportune moment, I got to designing. Thank you for the suggestions!!

There are two versions of this, no pause version, and a pause version. for the no pause, you can just print it and add an 8-32 nut after the fact to install it to a drawer or cabinet.

For the pause version you will add a pause at layer 28 (if printing at .2 layer height) this is the topmost layer just before that cavity for the nut gets sealed up with filament. during the pause, add an 8-32 nut and then resume.

I used these 8-32 nuts and screws: Click here

This design does not need any supports.

I hope you enjoy! -Billy