Bear Ice cream Cup (split to parts)

Bear Ice cream Cup, split to parts. Fits a 1 pint ice cream perfectly so ben and jerrys, hagendaaz etc. Also available is a multi colour version, a 4 colour print. This version does require some supports Id suggest painting manual supports to critical areas. Which is largely where the pieces fit. The rest of the bear prints fine with no support.

in this build there are no connectors, its just some glue to attach. Fairly straightforward as what goes where therefore i don't think it needs specific instructions. The only area id advise to be careful is the eyes. make sure you pay attention to the left and right pieces and don't mix them up as you could end up putting the in the wrong way.

Please ensure good adhesion as some parts are small

Ive set the main cup to 6% infill. the rest i would say between 10-15% 0.2 layer height

Also included is a version with no handle

Filaments, All Bambu basic. Brown Red White Light grey Black Matte Light blue Matte light pink