New to Fusion360, wanted to make a nozzle to control the flow of water into certain containers around my property.

A nozzle for garden hoses that is kinda shaped like a finger. I use it to fill jugs and my RV tanks. Works pretty good but it'll leak a few drops if you don't use a 1" rubber seal (I used 3/4" and it also works) if you're fine with a little dribble, it's no big deal. I printed with ASA 100% infill with no supports, not too hard of a print. Feel free to remix or copy if you want to add a hose port to a project of yours or tidy mine up. Curve is 60deg.

Took me less than 30 grams of filament to print.