My first ever kit-card design - chess pieces as a kit-card! Prints all flat - and then you have to assemble the set. As this is my first attempt on kit-cards, please feel free to comment with suggestions for future improvements. And enjoy!

Overview

The kit contains all default chess pieces:

• King
• Queen
• Bishop
• Knight
• Rook
• Pawn You can print them individually OR as bigger ‘sets’ in a single card!

Assembly

This should be fairly simple as all pieces only contains 3 elements:

• Snap/cut the elements free from the card
• Slide the 2 main elements together (one from the top, and the other from the bottom)
• Press the assembled piece down into the base (tip: do it while the base is flat on a table) If the fit is too loose, maybe a little glue can help. If it’s too tight, maybe a little sanding..

Print instructions

Here is a few suggestions:

• Speed: Low 1. layer speed (maybe below 50% of normal - just the first layer to ensure bed adhession with all the small lines)
• Orientation: The cards should be oriented correctly
• Brim: No. Would take a long time to clean the model..

Happy printing!