This model is a great way to showcase various textile patterns. There are four sizes, 4"x6", 5"x7", 6"x8" and 8"x8".

This model is intended to be used with a base textile, paired with a negative modifier. The 3mf will have the Dragon Con inspired pattern pre loaded with the negative modifiers. I've also included a "Benchy" STL that can be used as an STL modifier (see guide)

If you are starting from scratch, he recommended steps to create this process are the following:

1. Load in your base textile pattern (This is a free one to start with if you don't haven't downloaded any others - https://than.gs/m/1368954 )
2. Modify your base textile pattern with either an SVG or STL (see PDF guides)
3. Modify your base textile with the size of negative modifier you'd like (you'll use one of four frame sizes)
4. Load in the corresponding frame size
5. Verify that your base textile, negative modifier, SVG or STL modifier, and Frame are all in alignment with each other (you may have to slightly adjust them depending on where you'd like the textile to land within the frame)
6. Add a pause command to layer 2, where you'll place the fabric and magnets.
7. Wait until the print finishes and cools, remove it and trim away the excess fabric.
8. Place a small nail or tack at your desired location, and admire your print! (These make great gifts!)

If you have any questions, please send an email to Kaizen3DPrints@gmail.com

License Summary: Personal use only unless you hold a Commercial License. No resale or sharing of files. Selling printed models allowed only with an active Commercial License.