I was inspired to make these pencil toppers aka pencil umbrella aka "Pencibrella" when my pencil needed a little bit of shade :D

These are print on fabric models that have a small connector that a common #2 pencil will fit inside. You can also print the pencibrella stick and use it as a fidget toy. You could also put one on each end and use it as a flow toy, or wheels on a bus. Print one up and see where it takes you!

These are printed at a .24mm layer height. The 3mf has every option, in addition to full plates of the smaller versions, if you'd like to print up multiples to give out at Halloween as a non candy treat :)

There is a pause command placed at layer 2, where a mesh of your choice can be added (I prefer using illusion mesh for these but power mesh can add a fun bounce to them). Resume the print and remove the excess mesh after the print is completed.

Refer to the printing on fabric guide PDF included with this model for links to materials and extra tips & tricks.

If you have any questions, send me an email at Kaizen3DPrints@gmail.com