BLOB CHOCOLATE BUNNY

This chocolate version of the Blob Bunny has all the same features as the original but it's poor ear has already been snacked on. You can add a bowtie to dress up your bunny, and if you have a multicolor printer you can print white chocolate drizzle on it's body. The chocolate bunny even comes with a magnetic Easter egg.

Features

• flexi legs
• articulating head
• magnetic egg
• bowtie
• prints without supports
• print in parts or multicolor

PERSONAL USE ONLY

Purchasing or downloading this file does not give you the right to sell physical prints of this design. Commercial license is available for this design by subscribing to patreon.com/bloblab

COPYRIGHT PROTECTED FILES

All Blob Lab designs are protected under copyright law. Your purchase does not give you the right to sell or distribute the digital files in any way.

FILAMENTS

If you'd like to purchase the same filaments and supplies used in this design, please check out the Blob Lab Amazon Storefront affiliate link amazon.com/shop/bloblab3d

PRINT INSTRUCTIONS

• .12mm layer height recommended for high quality
• 3 perimeters for joint strength
• print without supports
• pause at the 4mm mark to add a 3x10mm magnet to the head, pause at 10.8mm for the egg
• eyes snap into head, use superglue if too loose, scale parts or adjust X-Y compensation if needed
• glue on ears and nose
• snap head on to body
• 3MF files are for color information only, print settings may need to be adjusted