This is an Oculus Quest wall mount that has been optimized to save on filament and printing time while still being strong enough to hold your tech!

There are 2 designs

• Hex Pattern: Saves the most filament
• Plain: Removes the hex pattern if you prefer that look

Hardware

• 4x Drywall Screws (I would recommend at least 2)
• VHB Tape (Not necessary if you use screws) -- Be warned! If you only use tape, how well this stays on your wall is completely dependent on the tape - I recommend using at least 2 screws!

Print Settings Walls: 4 Infill: 20% Top/Bottom layers: 5

Happy printing!