2-in-1 Heart Fidgets: 2 Styles (with and without magnets)

With magnets = Clicky Ratchet Fidget + Spinning Top Without magnets = Rotating Fidget + Spinning Top

You get twice the fun with these two-in-one fidgets ❤️ With magnets, this fidget is a clicking ratchet fidget and, when separated, the bottom is a spinning top. Without magnets, it’s a rotating fidget and, when separated, the bottom is a spinning top. These are perfect for Valentine gift exchanges 💕

If you print the fidget with magnets, you will need (8) 6mm x 3mm neodymium magnets for each fidget (4 magnets for each half of a fidget)

Here is an Amazon link to the magnets I used: https://amzn.to/4237IAb

3D Print Settings: 0.2mm Layer Height 15% Infill No supports needed Outer Wall Speed 100mm/s *Make sure to orientate the magnets correctly:)

I have also included a 3MF file with the following print profiles:

Print plate #1 (all parts of heart fidget with no magnets): 2 colors Print plate #2 (all parts of heart fidget with magnets): 2 colors; pause added at layer 19 (layer height 3.80mm) to insert magnets (make sure to orientate the magnets correctly - see photo) Print plate #3 (pin & heart fidget bottom with magnets & stripes): 2 colors, pause added at layer 19 (layer height 3.80mm) to insert magnets Print plate #4 (heart fidget top with magnets & stripes): 2 colors, pause added at layer 19 (layer height 3.80mm) to insert magnets

To assemble, insert the pin into the center of the heart bottom piece, if needed you can add some super glue.

Have fun printing! 💕