This Hueforge is based on a picture I took in Åre while riding a Skidoo up a trail. An elk appeared and stopped and stared at me, shortly followed by her children who crossed the trail behind her, and vanishing off into the white.

I used the following colours in this print, but any black, white, light grey and dark blue will probably work:

• PLA BambuLab Basic Black
• PLA+ eSun Dark Blue
• PLA BambuLab Basic Gray
• PLA BambuLab Basic Jade White

Fyrby Additive holds a commercial Hueforge license.

Printing

There is a pre-configured 3MF for Bambu studio. Non-Bambu users can use the 3MF in conjunction with the Hueforge describe information to achieve the prints.

This Hueforge is setup to use a 0.2mm nozzle and expects a 0.1mm bottom layer and a 0.08mm layer height with 100% infill and 1 wall.

If you find this model useful it would be great if you can support me by subscribing to me here, if only for a month. Thank you!