GF Pliers Holder 2x4.stl
337 downloads · 2 years ago · This bin started off as a 2x4x10U Gridfinity bin modified to hold up to 6 sets of pliers in at ~45 d
This bin started off as a 2x4x10U Gridfinity bin modified to hold up to 6 sets of pliers in at ~45 degrees. Since there was extra room on the front I cut out the profile to make a little bin you could use to hold parts while working.
If you want to save some filament you could slice off at least 10mm from the top.
GF Pliers Holder 2x4.stl
337 downloads · 2 years ago in  andÂ
Bundle
Pegboard - Single Pliers Holders
Pegboard pliers holder for Multiboard
_V1.1_-_A.png&w=3840&q=75)
ToolGrid - Small Pliers Holder
MultiBoard Compatible Needle Nose Pliers Holder
Plier holder
Gridfinity Pliers Holder
Gridfinity Wide Pliers Holder
SORTSET Needle Nose Pliers Holder 22x40mm for Multiboard
Gridfinity Pliers Holder 3 in 7x2 in 2 parts
Yet Another Multiboard Pliers Holder
Gridfinity Needle Nose Pliers holder v1.stl
Pliers Holder
Gridfinity Pliers Holder Inclined 3 in 7x3
Gridfinity Small Plier Holder
Gridfinity Pliers Holder 3 in 5x2
Gridfinity 45 Degree Pliers Holder
Gridfinity Closed End Pliers holders
Gridfinity Pliers holder
Multiboard Parkside Crimping Pliers Holder
