Universal Pliers and tool Holder and cable management Multiboard remix 3d model

Universal Pliers and tool Holder and cable management Multiboard remix

2.3K downloads · 2 years ago · I made a multiboard holder for pliers but realized it functions for quite a few other tools. It prin

This model is restricted by licensing terms.

View license.

Description

I made a multiboard holder for pliers but realized it functions for quite a few other tools. It prints within the constraints of a single multiboard snap and is oriented ready to print for strength of the part.

Tags:

Community Makes (1)

I sliced off the bottom so I could print it in the shown orientation. No functional issues with the shown prototype (printed at 200% speed).

Community Makes (1)

Discussions

bryan.murphy00012 years ago

I sliced off the bottom so I could print it in the shown orientation. No functional issues with the shown prototype (printed at 200% speed).

Layer height0.2 mm

Infill density15 %

SupportsNone

mykeypolomchak1 year ago

this will hold all but my 10mm wrench. any chance for a smaller one?

cris113682 years ago

This prints without supports?

bryan.murphy00012 years ago

I sliced the bottom off so I could print without supports in a stronger orientation. It's working well enough for my purposes. I'll post a make so you can see what I did.

el.cannibal2 years ago

I printed this with line supports off the baseplate only, but if the bridging on your printer is good you could probably print it without supports if you rotate it onto the multiboard plug side.