Follow
Zipper Pull - Skull Face
25 downloads · 6 months ago · Boring zippers no more! Don't get spooked by this one! 💀
**Items you need:**
- 2 x “4mm x 30cm” pa
Boring zippers no more! Don't get spooked by this one! đź’€
Items you need:
- 2 x “4mm x 30cm” paracord.
- *4 x “3mm (diameter) x 2mm (thick)” magnets (neodymium magnets are recommended for better holding power).
- 2 x “12mm” wiggly eyes.
- Super glue (for the eyes, mouth and magnets).
*If you do not have magnets, I have included a 3D-printed Connector.
Suggested print settings for the Main Body:
- Layer height 0.2mm.
- Infill 30%.
- Position the print in a way that the joining face is facing downwards.
- No supports are needed.
Suggested print settings for Mouth:
- Layer height 0.2mm.
- Infill 15%.
- Brim: Width 2mm (optional). -- Brim Separation Gap: 0.2mm.
- Position the print in a way that the chamfered side is facing upwards.
- No supports are needed.
ASSEMBLY Affix the mouth to the main body with the chamfered side facing downwards.
NOTE Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.
This work is licensed under a Creative Commons (4.0 International License) Attribution—Noncommercial—Share Alike
Categories:
13Â Likes25Â DownloadsJuly 9, 2024