Boring zippers no more! Expanding the Zipper Pull collection - tempting but do not dunk this one. 🛑🥛😆

Items you need:

• 2 x “4mm x 30cm” paracord.
• *4 x “3mm (diameter) x 2mm (thick)” magnets (neodymium magnets are recommended for better holding power).

*If you do not have magnets, I have included a 3D-printed Connector.

Suggested print settings for the Main Body - Cream:

• Layer height 0.2mm.
• Infill 30%.
• Position the print in a way that the joining face is facing downwards.
• No supports needed.

Suggested print settings for Biscuit:

• Layer height 0.2mm.
• Infill 15%.
• Position the print in a way that the joining face is facing downwards.
• No supports needed.

ASSEMBLY Align the notch and cavity for the "biscuit" and affix in position using glue. Verify that the text is correctly positioned.

NOTE Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.

This work is licensed under a Creative Commons (4.0 International License) Attribution—Noncommercial—Share Alike