7 Likes9 DownloadsAugust 20, 2024
Connector for the Zipperrific's zipper pull collection.
Suggested print settings:
- Layer height 0.2mm.
- Infill 50%.
- Perimeters: 5.
- Refer to the image for print orientation.
- No supports needed.
ASSEMBLY Choose which side (Zipper Pull) you'd like the connector piece to stay, and insert the longer end all the way in. Slight force may be needed.
NOTE Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.
This work is licensed under a Creative Commons (4.0 International License) Attribution—Noncommercial—Share Alike
Category:
7 Likes9 DownloadsAugust 20, 2024
7 Likes9 DownloadsAugust 20, 2024